100% Actives
Basement Waterproofing Sealer
Vapor-Tek 440
Two-component
Best used on concrete floors with a high moisture content (up to 20lbs/24hr/1000ft) or prior to installing wood, carpet, tile or epoxy flooring
If a concrete floor has a high moisture content the Vapor-Tek 440 is the product to use. This two-component epoxy floor coating is designed to reduce moisture vapor emission rates of up to 20lb/24hr/1000ft. If you are going to be installing carpet, tile or wood this is the product to use to prevent any moisture from traveling and dis-bonding the flooring. It is also an excellent choice to use the Vapor-Tek 440 as a primer before installing an epoxy floor.
Each gallon will cover up to 100 square feet at 16 mils thickness and will leave a clear, high gloss finish. Part A is mixed with Part B prior to application and installed with an epoxy glide roller. The Vapor-Tek 440 will stop dusting, can be applied to concrete as little as 10 days old and only requires one coat.
The Vapor-Tek 440 does have a short pot life which means once Part A and Part B are mixed together it needs to be applied within 5-25 minutes. Once the pot life has been reached the product can no longer be applied. Mix in smaller batches following the 2 Parts A to 1 Part B ratio to extend the pot life. The Vapor-Tek 440 is dry and ready for foot traffic within 24 hours and fully cured in 3-7 days.
Lithi-Tek 9500
Water Repellent
Water-Based
Concentrated
Best used on concrete driveways that are not exposed to deicing salts or winter climates.
The Lithi-Tek 9500 is an excellent and cost effective concrete driveway sealer for driveways that will not be exposed to freeze-thaw cycles, winter climates or deicing salts. Only available in an ultra concentrated version, the 9500 is mixed with 4 gallons of distilled water prior to application. Two coats are easily applied wet-on-wet with a sprayer, roller or brush.