Only mix with water. Mix solution slowly in an open-top plastic container. Stir gently. Ratio varies by desired use: for a light cleaning, ten (10) parts water to one (1) part Micro-Degreaser 1100; for moderate cleaning, four (4) parts water to one (1) part Micro-Degreaser 1100 and for heavy cleaning, one (1) part water to one (1) part Micro-Degreaser 1100.
Always test a small area before application to ensure desired ratio, etch time, coverage rates and to verify application technique.
- Apply using a low-pressure pump sprayer. Allow the solution to sit on the substrate for two (2) to ten (10) minutes. If necessary agitate with a stiff bristle nylon brush or broom. Flush thoroughly with clean water. Repeat the process as needed. You do not need to neutralize after using Micro-Degreaser 1100.
Clean equipment and tools with hot soapy water. Unused or old material may be disposed of in a waste disposal site in accordance with local, state and federal laws.
- Proper application is the responsibility of the user.
- Make sure the most current versions of product data sheets and SDS are being used.
- For professional use only. Keep out of reach of children.
Avoid contact with skin, eyes and clothing, do not take internally. Use appropriate safety equipment during application and handling. Please refer to the safety data sheet (SDS) for additional precautionary instructions before use.